Industrial standard plug made of brass, stainless steel, PBT and other materials resistant to corrosion and wear with a _ male NPT for your automotive and other repairs. It has a 3/16 pilot and a flat bottom V- shaped ball groove.
Accurate pressure regulation with maximum water and dirt separation are provided in a single, compact unit. The filter significantly increases the life of expensive equipment, such as air tools, air valves, air cylinders and air motors.
This nylon recoil hose retains its self-coiling properties and stores itself when finished. Can be used with all air-powered equipment on the job site and in garages, plants and service stations. The swivel end fittings reduce hose twist.
Prevents burn-out, stops rust and increases torque up to 25 percent. A compact oiler that fastens directly to the air tool. Precisely meters proper amount of oil to the tool only when the tool is in use.
Solid piston is impervious to most chemicals and a wide range of lubricating oils and greases. Resists rupture, cracking or tearing under pressure, constant flexing or high cycle rates . Provides accurate control and assures smooth, uninterrupted operation. Fast reverse flow capability allows for installation where dual pressures are required.
Tru-Flate design 3/8 inch body series female NPT 1/4 inch steel. Utilizes the tubular valve which supports the seal and allows more air flow at lower pressure drops than most competitive couplers. Protective collar guards against accidental disconnect. Due to their large size, intended for compressed air lines only.
Air line filters compact series polycarbonate port size 3/8 inch filtration removes airborne solid contaminants which may cause wear or failure of pneumatic components. All filters are complete with filter element and either manual or automatic drains. Maximum operating pressure is 150 PSI at 125 degree Fahrenheit with polycarbonate bowl.
Coupler plug made of brass, stainless steel, PBT and other materials resistant to corrosion and wear with a _ female NPT for your automotive and other repairs. Threaded to connect to a male hose fitting, it also has a long _ pilot for a tight seal within a sleeved coupler.
3/8 in. Automotive standard series type G. Plated steel couplers have hardened steel balls and stainless steel springs. Coupler plugs are heat treated to reduce wear on critical mating surfaces. Maximum working pressure is 300 PSI.
1/4 in. Industrial interchange series type D. Plated steel couplers have hardened steel balls and stainless steel springs. Coupler plugs are heat treated to reduce wear on critical mating surfaces. The industrial interchange series couplers interchange with Aro, Foster, Milton, units produced by other manufacturers. Maximum working pressure is 300 PSI.